GO Devil Flat Bottomed​ Wireline Fishing Tool

I. Overview:
GO Devil Flat Bottomed are used to cut stuck tool string wires.
Flat bottom wire cutters consist of a solid rod with grooves and guide surfaces. It is run into the well in the conventional manner, where the wireline tool is heavily buried by sand, debris, or wire, or without a single cut. Flat-bottomed wire cutters provide a solid cutting surface for sloping-bottomed wire cutters or wire scissors.
The steel wire cutter has a positioning groove for installing the slip centralizer, which can be used in large-diameter oil pipes after the slip centralizer is installed.

II, the commonly used technical parameters:

III. Structural characteristics and use:

The GO Devil Flat Bottomed is composed of a slotted flat bottom solid rod and a baffle. The baffle is connected with the slotted solid rod by screws. When using, remove the baffle, insert the wire into the slot, and then install the baffle. The steel wire cutter goes into the well along the steel wire and assists the inclined bottom steel wire cutter to cut the steel wire. The wire cutter and tool string are then fished out with a catcher.
IV, matters needing attention:
After using the flat bottom wire cutter, timely and careful maintenance will prolong the service life of the tool.

Welcome to contact us at any time.